Paver Driveway Installation
Driveway installation in Venice, done right: how we build a paver driveway that stays flat for decades, and what install day looks like.
What Good Driveway Installation in Venice Looks Like
Good driveway installation in Venice is mostly about what you never see. The pavers on top only last as long as the base underneath, the slope that moves water away and the edges that hold everything together.
So our crews spend most of the day below the surface. First, we excavate to driveway depth. Then we build the base in compacted lifts, set the slope, screed the bedding layer and only then lay pavers. Finally, we install edge restraint and compact joint sand so the whole field locks together.
For new homes, we also work with builders. See new-construction driveways on venicepavers.com.
Our Driveway Installation Process
1. Layout and removal
We mark the layout, then break out and haul away any old concrete or asphalt.
2. Excavation
Next, we dig to driveway depth, which is deeper than a patio, and check the soil underneath.
3. Base in lifts
We place crushed stone and compact it in layers, so it will not rut under tires. Learn why in the base guide.
4. Slope and bedding
Then we set the pitch away from the garage and screed a level bedding layer.
5. Pavers and pattern
We lay vehicle-rated pavers in your pattern, usually herringbone for strength. See the pattern guide.
6. Edges, sand and compaction
Finally, we install edge restraint, sweep in joint sand and compact the surface so the pavers interlock.
What to Expect on Install Day
Most driveways in a day
Once any old concrete is out, we finish most residential driveways in a single day.
Plan for access
Move cars out of the driveway and off the street in front of it, and keep the garage closed.
Walk on it right away
You can walk on new pavers right away. However, wait 24 to 48 hours before driving on them.
Final walk-through
At the end, we walk the driveway with you and explain cleaning, care and sealing options.
For a fuller picture of the whole process, read the paver driveway timeline. You can also see how we approach installs on our installer page on venicepavers.com.
From First Call to Finished Driveway
Free walk-through
First, we visit, measure the driveway, check grades and drainage, and talk through how you park and use it.
Written estimate
After that, you get a layout, paver and color options, and an itemized written estimate before any work starts.
Install day
Then our crew removes the old surface, builds and compacts the base, lays the pavers and sets the edges.
Final walk
Finally, we walk the finished driveway with you and explain care, cleaning and when you can drive on it.
Driveway Installation FAQs
How deep do you dig for a paver driveway?
Deeper than a patio, and the exact depth depends on the soil and the loads. We specify it on the written estimate. Our base guide explains typical ranges.
Do you remove my old driveway?
Yes. Removal and haul-off of old concrete or asphalt is part of the job when you are replacing a driveway.
Which pavers do you install?
We install vehicle-rated pavers from Tremron, Belgard, Flagstone, TriCircle and Oldcastle, and we are a manufacturer-certified Tremron installer.
Can you install pavers for a new home?
Yes. We work with homeowners and builders. See new-construction driveways for builder projects.
Get a Driveway Built Right the First Time
Book a free walk-through, and you will get a written, itemized installation estimate.
Get a free estimate 941-413-1109